Incubating eggs: our setup, our results, our mistakes
What actually works when you’re hatching your own stock in a small operation.
We’ve been hatching our own eggs for over a decade. The setup has evolved from a single small incubator to a system where we can turn several hundred eggs a season. Here’s what we use, what we’ve learned, and where we’ve gone wrong.
The setup
We use [describe your incubators — brand, size, automatic/manual turning]. The key parameters:
- Temperature: 37.5–37.8°C for chicken, 37.5°C for duck. We monitor with a separate thermometer, not just the incubator’s built-in sensor.
- Humidity: 40–50% for the first 18 days (chicken), 60–70% for the last 3 days. For duck: 50% for the first 25 days, 65–70% for the last 2.
- Turning: Automatic in our units. If you’re using a manual incubator, turn at least 5 times a day. More is better.
- Ventilation: More than you think. A sealed incubator in a warm room will kill your batch.
What we’ve learned
Selection matters more than equipment. The incubator is the easy part. Choosing which eggs to incubate is harder. We select for: size, shell quality, and — most importantly — the performance of the parent birds. A hen that lays consistently and produces vigorous chicks is worth more than a pretty bird.
The first week is the kill zone. Most of our losses happen in days 1–7. Embryonic development is fragile. Temperature fluctuations, poor egg quality, or a fault in the incubator will show up here. If your hatch rate is low, check your first-week conditions before you blame the last three days.
Don’t open the incubator in the last 72 hours. The chicks are positioning themselves. Opening the door drops the humidity and can cause “pasting” or deformities. We learned this the hard way.
Duck eggs are different. Longer incubation (28 days vs. 21), larger, more sensitive to humidity. We treat them differently from the start.
Our mistakes
- A thermostat failure that we didn’t notice for 36 hours. Entire batch lost. Now we have a separate temperature alarm.
- Incubating eggs from birds that were too young. The eggs looked fine. The chicks were weak. We now only incubate from birds that have completed at least one full laying cycle.
- Overcrowding. We tried to fit more eggs in than the incubator was rated for. Airflow suffered. Hatch rate dropped. We’ve gone back to the manufacturer’s recommended capacity.
What’s coming
When we move to Paraguay, the incubation setup comes with us. The climate will be warmer, which changes the ventilation requirements. We’ll document that when we get there.